SKYJACK, Page 96
SJRT Compact Series
Engine Powered
Maintenance and Inspection
Death or injury can result if the work platform is not kept
in good working order. Inspection and maintenance
should be performed by competent personnel who are
familiar with mechanical procedures.
The operator should be assured that the work platform
has been properly maintained before using it. Included in
this section is information on lubrication and inspection
points that require maintenance.
Even if the operator is not responsible for the maintenance
of this work platform, the operator should perform the
daily inspections found in
Table 2.6
- Maintenance and
Inspection Schedule.
IMPORTANT NOTE
Replace all worn or damaged parts or labels
discovered during this inspection. Any
problems or malfunctions that may affect the
safe operation of this work platform must be
repaired immediately.
WARNING
Maintenance must be performed by
trained and competent personnel who
are familiar with mechanical procedures.
Death or serious injury could result from
the use of an aerial platform that is not
properly maintained or kept in good work-
ing condition.
WARNING
Do not reach through the scissor assem-
bly when the platform is raised without
the maintenance support properly posi-
tioned. Failure to avoid this hazard could
result in death or serious injury.
Maintenance and Inspection Schedule
• The inspection points covered in
Table 2.8
indicate
the areas of the aerial platform to be maintained or
inspected and at what intervals the maintenance
and inspections are to be performed.
• The actual operating environment of the aerial
platform may affect the maintenance schedule.
WARNING
Use original or manufacturer-approved
parts and components for the aerial
platform.
Owner’s Inspections
It is the responsibility of the owner to arrange daily,
quarterly (or 150 hours) and annual inspections of the
aerial platform. Refer to
Table 2.8
for recommended
maintenance and inspection areas and intervals. A
record of annual inspection is kept on a label located
on the scissor assembly. Refer to
Table 2.2
- Owner’s
Annual Inspection Record in
section 2
is to be used for
recording the date of inspection, owner’s name and
the person responsible for the inspection of this work
platform.
General Maintenance Hints
• Before attempting any repair work, disconnect
battery ground negative (-) lead.
• Properly position maintenance bar if the scissors
assembly is raised.
• Preventive maintenance is the easiest and least
expensive type of maintenance.
Go
to
Discount-Equipment.com
to
order
your
parts
