146
SJ6826RT, SJ6832RT
213560ABA
2.
If the tachometer reads 3500 ±50 rpm , the
high throttle rpm is already properly set. Skip
to Step 8 to check the low throttle rpm. If the
tachometer reading is outside of the range given
above, proceed to the next step to adjust it.
3.
Adjust the length of the stroke by first loosening
the jam nut, then turning the threaded link
and measuring the rpm until it reaches
3500 ±50 rpm.
4.
Once the correct rpm is reached, apply a drop
of Loctite 242 to the thread, and tighten the nut
against the threaded link. Use vice grips to hold
the link stationary, and a wrench to tighten the
nut.
1. Turn threaded
link
2. Tighten nut
Low Throttle Check and Setting
5.
Measure the rpm using a digital tachometer, as
described in Step 2.
6.
If the tachometer reads 2050 ±50 rpm , the low
throttle is already properly set. No further action
is required. If the tachometer reading is outside
of the correct range, proceed to the next step to
adjust it.
7.
Adjust the length of the long threaded bolt by
turning the locknut and measuring the low
throttle rpm until it reaches 2050 ±50 rpm.
8.
Once the correct rpm is reached, apply a drop of
Loctite 242 to the thread of the long bolt. Tighten
the jam nut.
To
order
go
to
Discount-Equipment.com
