Rough Terrain Scissors
December 2007
Page 51
Section 3 - Operation
Loading/Unloading
3.9 Loading/Unloading
Know all national, state or territorial/provincial and local rules which apply to your loading/unloading of aerial
platforms.
Only qualified personnel shall operate machinery during loading/unloading.
Be sure vehicle capacity and loading equipment hoists, chains, straps, etc., are sufficient to withstand maximum
aerial platform weight.
The transport vehicle must be parked on a level surface and must be secured to prevent rolling while aerial
platform is being loaded/unloaded.
3.9-1 Lifting
When it is necessary to lift the Skyjack aerial platform the following conditions must be met:
• The platform must be fully lowered.
• The main power disconnect switch must be in “
” off position.
• The hydraulic/fuel and engine compartments must be closed and securely latched.
• The extension platform must be retracted and secured.
• The platform control console must be secured to the railings or removed.
• The platform must be cleared of all personnel, tools and materials.
• The lifting/rigging must be attached to all four lifting points as illustrated in
Figure 3-6
.
Tie down/
lifting points
Figure 3-6. Tie Downs/Lifting Points
NOTE
The mass of the aerial platform is as per
Table 4.2
. The center of gravity is approximately located in the
middle of the aerial platform, front to back and side to side, as illustrated in
Figure 3-7
. Vertically, the
center of gravity is approximately just above the base chassis.
Center of
gravity
Center of
gravity
Figure 3-7. Center of Gravity
Summary of Contents for SJ 68RT Series
