TM
Page 60
December 2007
DC Electric Full-size RTs
Tables
Section 2 - Operation
Table 2.6 Tire Specifications
wARNiNG
Air pressure can affect stability. Temperature changes can affect air pressure. It is important to
visually inspect all tires for proper tire inflation prior to use. Tires should be checked by end user
on a daily basis. Tire inflation pressures must be checked weekly with a calibrated gauge. If the
measured pressure is less than the specification, reinflate to the pressure specified below. Tires
must not be inflated above the recommended specification. Do not intermix tires of different types
on one aerial platform. Use only tires of type originally supplied.
Backspace
Rim Size
10-16.5
4
¾"
75*
CARLISLE US LOADER
121 mm
(517.1)*
10-16.5 OTR OUTRIGGER
4
¾"
75*
(Non-Marking)
121 mm
(517.1)*
10-16.5
4
¾"
CARLISLE US LOADER
121 mm
10-16.5 OTR OUTRIGGER
4
¾"
(Non-Marking)
121 mm
60615AA-ANSI
*
†
Usage†
Fill Type
Ply Rating
Pressure (Factory)
(kPa)
8831E
8841E
#6A
Air
10
#6A
10
Tire Specification
Tire Size
S
O
S
O
O
O
O
#6F
Foam
10
N/A
#6F
10
N/A
(
N/A
) Not Available
Factory preset @ 20°
C, Check pressures regularly as tires can lose pressure over time and over different ambient temperatures even under normal
conditions.
Usage: (
S
)tandard Or (
O
)ptional
O
Backspace
Outboard
Inboard
SECTION A-A
A
A
Rim Backspace Diagram
wARNiNG
Intermixing tires of different types or using tires of types other than those originally supplied with
this equipment can adversely affect stability. Therefore, replace tires only with the exact original
Skyjack-approved type. Failure to operate with matched approved tires in good condition may
result in death or serious injury.
