SJ643 TH & SJ843 TH
216201ADA
19
Safety Precautions
Section 2 – Operator Safety
TETHER LOADS
that may
swing, keeping them close to the
ground. Provide ample clearance
for personnel to guide the load
safely.
SLINGING LOADS
is
acceptable only when the load
is appropriately attached to
the lifting hook, a jib boom or
the heel of a tilted fork, and the
precautions outlined in
Section
5.14
are followed.
KEEP OTHERS AWAY
at all
times during operation.
CHECK
lights for proper function
before operating.
ENSURE ALL
tires are in
good condition and lug nuts are
properly tightened.
IT IS PERMITTED
to install
and utilize a platform for elevating
personnel provided the conditions
mentioned in
Section 5.16
are
met.
DO NOT
alter or disable safety devices.
DO NOT
burn or drill holes in forks. Modifying any
part of telehandler or attachment affects its capacity
and/or stability.
DO NOT
try to start the telehandler by pushing or
towing. Such operation may cause severe damage to
the transmission (refer to
Section 5 – Operation
).
IF DRIVING ON ROADS OPEN TO PUBLIC
TRAFFIC
respect the local regulations.
THE OPERATOR’S CAB
provides a falling object
protection structure (FOPS) and a rollover protection
structure (ROPS). Do not make any modification to
this structure. If damaged, the cab cannot be repaired.
It must be replaced.
STUNT
driving and horseplay are prohibited.
ALWAYS USE FRONT
steering when traveling at
high speeds; i.e. on highways and public roads.
DO NOT
change steering mode while the telehandler
is traveling. Change the steering mode only when
telehandler is stopped.
ALWAYS
look in the direction of travel. Reduce
speed and be especially careful when traveling in
reverse and/or turning. Bring the telehandler to a
complete stop before changing the direction of travel.
STAY CLEAR
of pinch points and rotating parts on
the material handler. Getting caught in a pinch point
or a moving part can cause serious injury or death.
Before performing any maintenance on telehandler,
follow the shutdown procedure on
Section 5.10
.
DO NOT
position the telehandler against another
object to steady the load.
DO NOT
operate on slippery surfaces not capable of
providing adequate traction to stop, drive or steer the
telehandler.
SHUT DOWN
by positioning the telehandler in a
safe location. Lower boom to ground, apply the park
brake, move all controls to neutral and allow engine
to idle for 3 to 5 minutes. Stop engine and remove
ignition key to prevent unauthorized use.
WARNING
Always move all controls to neutral, engage
park brake and shut off engine before exiting the
operator’s cab.
Summary of Contents for SJ643 TH
