130
SJ82 T, SJ86 T
229040ABA
Section 4 – Troubleshooting Information
Electrical System
6.
No output on pin #22 of the valve driver to wire
#14.
Check pin #22 for minimum 3.5 volts. If no voltage
present with foot on footswitch check section 5 for
OCM pin voltage reference.
7.
Loose or broken wire #14 from valve driver pin
#22 to plug A pin #7 in platform control console.
Check continuity. Replace if defective.
8.
Loose or broken wire #14 in boom cable A or its
connectors.
Check for continuity between pins #7 on cable A.
Check for loose or corroded connections on cable
connectors. Replace if wire is defective.
9.
Loose or broken wire #14 from base connector
plug A pin #7 to base terminal block.
Check continuity. Replace if defective.
10.
Loose or broken wire #14 from base terminal
block to turret harness plug pin #4.
Check continuity. Replace if defective.
11.
Loose or broken wire #14 from turret harness
plug pin #4 to boom up valve 4H-14.
Check continuity. Replace if defective.
12.
Loose or broken wire #02 from turret harness
plug to boom up valve 4H-14.
Check continuity. Replace if defective.
13.
Defective boom up valve coil 4H-14.
Check continuity and resistance through coil.
Replace if defective.
No Boom Down
NOTE
Boom Down may be disabled by the dual load zone system and/or overload system if equipped. Please first
ensure the boom is fully retracted and there are no faults in the overload system.
1.
Loose or broken wire #04 from platform terminal
block to joystick controller A1.
Check continuity. Replace if defective.
2.
Loose or broken wire #02 from platform terminal
block to joystick controller A1.
Check continuity. Replace if defective.
3.
No output on y-axis of joystick controller A1.
Refer to joystick test procedure in section 5.
4.
Loose or broken wire “Y” from joystick controller
A1 to valve driver pin #29.
Check continuity. Replace if defective.
5.
No output on pin #5 of the valve driver to wire
#20B.
Check pin #5 for 12 volts. If no voltage present with
foot on footswitch check section 5 for OCM pin
voltage reference.
6.
No output on pin #8 of the valve driver to wire
#13.
Check pin #8 for minimum 3.5 volts. If no voltage
present with foot on footswitch check section 5 for
OCM pin voltage reference.
7.
Loose or broken wire #13 from valve driver pin
#8 to plug A pin #6 in platform control console.
Check continuity. Replace if defective.
8.
Loose or broken wire #13 in boom cable A or its
connectors.
Check for continuity between pins #6 on cable A.
Check for loose or corroded connections on cable
connectors. Replace if wire is defective.
To
order
go
to
Discount-Equipment.com
