191
SJ82 T, SJ86 T
229040ABA
Boom
Section 5 – Procedures
5.4-12 Fly Boom Section Installation
1.
Attach two lifting slings to the fly boom. Using
suitable lifting equipment, slide it slowly into the
nose of the mid boom. Be careful not to damage
the wear pads.
2.
When it is about 1/3 of the way in, install the
bottom wear pad. Apply Loctite 242 or 243 to the
wear pad fasteners.
3.
Place a suitable stand under the end of the
boom. Lower it onto the stand and remove one
lifting sling.
4.
Continue sliding the boom all the way in until the
holes in the boom tip and the e-chain support
bracket line up.
5.
Install the top and side wear pads and shims in
the mid boom nose. Apply Loctite 242 or 243 to
the wear pad fasteners.
6.
Install the fasteners for cable/hose tube support
in the fly boom. Connect the platform level
hydraulic hoses.
M62253AA
5.4-13 Platform and Jib Boom Installation
For torque specifications, refer to
2.2 MEWP Torque
Specifications
.
1.
Connect lifting slings to the jib assembly.
2.
Using suitable lift equipment, move it into
position and insert the jib pin and slave cylinder
pin. Insert the keeper pins.
M62020AA
3.
Connect the hydraulic hoses for the jib cylinder.
M62250AA
To
order
go
to
Discount-Equipment.com
