SkyLink TD-434, User Manual

12

To activate or deactivate the Timer:

1.  During the standby mode, press [TIMER] once [show LCD].

2.  Press [1 – 9] to select the desired timer, i.e. Enter [1] for Timer 1.

3.  Press [TIMER] again to activate or deactivate the timer. If the Timer icon stays  

  on, the timer is activated. If the Timer icon is off, that timer is not activated.  

BaTTErY

When the operating range is reduced, the LCD backlight is dimmed, or the red LED 

does not flash during operation, it is time to replace the battery.

The remote is powered by 2 AAA alkaline batteries. Follow the instructions below to 

replace the batteries to the transmitter.

1.  Slide out the battery door from the unit.

2.  Remove the old battery. Insert 2 new AAA Alkaline batteries to the battery    

  compartment. Beware of the battery polarity.

3.  Insert the battery door to the remote. The red LED on the front of the unit will   

  be on for 1 second and the LCD will turn on. 

After replacing the batteries, please refer to the Section 3 “Set the Clock”, to set 

the current time. There is no need to program the devices, zones, timers or scene 

settings,  these  settings  are  stored  in  the  memory  without  being  affected  by  the 

battery.  

caution:

 Risk of explosion if battery is replaced by an incorrect type. Dispose of 

used batteries according to the instructions.

cE

Declaration of Conformity

This equipment complies with the requirements relating to electromagnetic compat-

ibility, EN 300220-2, EN301489-3, EN61058-1, EN50371. This equipment conforms 

to the essential requirement of the Directive (1999/5/EC) of the European Parlia-

ment and of the Council.