SkyLink TD-434, User Manual

6

1.  Put the receiver control that you plan to program into programming mode.  

    Refer to the User’s Instructions of that receiver control.

2.  During the standby mode, the LCD display will show the current time. Press    

  the [PROG] button once to enter the Individual Programming mode. The  

  Signal icon [      ] and red LED stays on for 15 seconds. 

3.  Once the receiver control is in programming mode, press the button [1 – 9] on  

   the remote that you plan to use to transmit the “Learn” code. Red LED  

  will flash and then off. The signal icon will disappear indicating the “Learn”    

  code is sent.  

4.  Once the remote is programmed, the receiver control will quit from  

  programming mode and the programmed remote is ready to be used now.

PrOgrammINg fOr ZONE OPEraTION

In  the  above  table,  both  the  Family  Room  Ceiling  Light  and  Family  Room  Floor 

Light are in zone 1. You need to assign the zone 1 signal to both receiver controls 

in these 2 locations.

That means for Light 1 in the example, you need to program the following signals:

-  Button 1 to Light 1 based on Programming for Individual Operation

-  Zone 1 Command to Light 1 base on Programming Zone Operation

  For Light 2 in the example, you need to program the following signals:

-  Button 2 to Light 2 based on Programming for Individual Operation

-  Zone 1 Command to Light 2 base on Programming Zone Operation

To assign a zone to a receiver control, follow the instructions below:

1.  Put the receiver control that you plan to program into programming mode.  

  Refer to the User’s Instructions of that receiver control.

2.  During the standby mode, the LCD display will show the current time. Press    

  the [PROG] button 3 times to enter the Zone Programming mode. The  

  Signal icon [   ] and ZONE icon and red LED stay on for 15 seconds.