SkyLink TD-434, User Manual

8

4.  Now the Red LED stays on and the SCENE icon, Signal icon and Settings  

  icon stay on for 15 seconds to allow you to program this scene to the  

  receiver control.

5.  Put the receiver control that you plan to program into programming mode.  

  Refer to the User’s Instructions of that receiver control.

6.  Once the receiver control is in programming mode, press the Scene  

  number button on the remote, i.e. [1] for Scene 1. Red LED will flash then  

  off. You have now programmed a Scene 1 signal with 60% brightness to  

  the receiver control. The LCD display will continue to show the setting for  

  Scene 1 with the brightness setting flashing. 

7.  As most scene setting involves multiple lights with different brightness, you    

  may change the brightness again and program the same scene to another    

  receiver control. 

8.  After finish programming all the scenes, you may press the PROG button 

   twice to return to clock mode. 

Scene Operation:

To turn on a scene

:

1.  Press the Function button “F” once. The SCENE icon and ON icon will stay    

  on in the LCD display. [show LCD]

2.  Press [1 – 9] to select the desired scene, i.e. Enter [1] for Scene 1 and all  

  the lights in Scene 1 will be on at the preset brightness.

To turn off a scene:

1.  Press the Function button “F” twice. The SCENE icon and OFF icon will stay    

  on in the LCD display. [show LCD]

2.  Press [1 – 9] to turn off the scene, i.e. Enter [1] to turn off all the lights in  

  Scene 1.