E_MH_Mounting_instructions_Skylux_Cintralux_Alu_25mm_fixed_parts_flat_curb
01/04/2020
10/20
Aligning:
Align the vertical edge of the lateral profile of flat curb LP125 with
the outside of the finished long side of the curb.
Screw the lateral profile for flat curb LP125 onto the curb with the screws supplied (Ø 6,5 x 50 mm with neoprene
seal), with a spacing of 500 mm, each time between two brackets. For this, use the screw line provided in the
lateral profile LP125.
Important: always use the right screws depending on the type of curb (metal screws for a metal curb, wood screws
for wood, etc.).
Several lateral profiles are linked together by means of
connector 46580, which is already clamped in the lateral
profiles.
The connector also ensures a play of 5 mm (± 2 mm) between the lateral profiles.
Seal the seams between the lateral profiles LP125 so that water dripping onto the lateral profile cannot seep
inside.
Seal the corners (where lateral profile LP125 and
bottom profile end piece LP725 come together)
After that, mount the
lateral profiles LP125 in the same way on the other side of the long side of the curb.
Important: ensure that the lateral profiles LP125 lie perfectly two by two in parallel and are connected to each
other at the correct distance, so that an
equal daylight opening is obtained everywhere.
LP125
Lateral profile for flat curb
+ foam sealant 15 x 15 mm
Screw Ø 6.5 x 50 mm
LP725
Bottom profile end piece
+ foam sealant 8 x 10 mm
46580
Front lateral profile connector
500
afkitten
5 mm
