20/11/2020
33/88
E_MH_Installation_instructions_Skylux_Climax
Supports and side supports
Installation using connectors and glass
Fasten connectors K on to the hinge profiles using parker screws PST. Drill holes with a Ø of 4 mm in advance at
the indicated lines (left and right) of the connector. The holes are to be drilled to the left and right of the support,
both on the wall and gutter side. Cut away one wing of the connector when installing the side supports using K
connectors to ensure that the connector is not in the way laterally with regard to the finishing profile.
Allow for a clearance of at least 5 mm the side support will be fixed against a wall. Install spacers A1 or A2 between
the supports on hinge profile S1 or S2. The support seal C5 (for plastic sheets) or support seals C5 + C31 (for glass)
will be installed here.
Slide the TP(G) profile completely up against the wall profile and fasten these AS HIGH AS POSSIBLE using 2 ZSG
screws with a neoprene O-ring. Ensure that all gutter side stop profiles area aligned. The TP(G) profile expands
downwards.
See page 57 for installation tips for a Climax system with thermal bridge when using double glazing.
C31
C5
A1/A2
ZSC
PST
K
D1/D2/D3
ZSC
PST
PST
K
K
ZSB
ZSB