20/11/2020
37/88
E_MH_Installation_instructions_Skylux_Climax
Finish
SUPPORTS
Screw-in type clips
For plastic sheets or glass: The glazing thickness and options are provided in the table on page 84.
Drill holes with a Ø of 5.5 mm in the CLSB every 500 mm, starting and ending at 200 mm from the ends. Fasten
the CLSB to the TPG using adapted Hi-Lo screws. Fasten perpendicularly and use a slight torque to ensure the
screw head is pressed flat against the CLSB. Either single screws and/or adaptor profiles Y10/Y25 must be used
depending on the glazing thickness (see the table on page 84). The CLST clips must be fastened manually using a
seal hammer and a plank. Ensure the clips are not dented.
The screw-in type clips consist of 2 parts:
- CLSB bottom clips
- CLST top clips
Push seal C8 or CY10 on both sides into the CLSB clips.
Ensure that seal C8 does not continue up to the end of the
gutter side but to the end profile on the glazing.
500
200
C8
CY10
CLST
CLSB