20/11/2020
41/88
E_MH_Installation_instructions_Skylux_Climax
Finish
GUTTER GD2 + G
Do not forget to apply silicon sealant that does not affect plastic material to the end profiles on the plastic sheets
on the gutter side.
POSTS
click
GD2C
G
Y10
Y16P
GD2
Fasten the detail of the GD2C with a clip into plastic
profile Y16P. Once it is in the correct position, free the
adhesive strip completely and push the GD2C against
the gutter.
Gutter support GD2 is finished with GD2C. Cut the
profile longitudinally at the indicated position. The
length of GD2C matches the distance between the
walls and/or posts. Add silicone adhesive over the
complete length of the ribbed zone. Free the ends of
the adhesive strip and fold these outwards.
ZSG
ZSG
click
Add the water outlet pipe and connect it to the
rainwater drain pipe. Install the PC cover clips to the
post.
Check whether the posts are completely vertical
(level) and fasten each top and bottom section in
the U-brackets using coated ZSG screws. Drill holes
with a 3 to 4 mm Ø in advance to avoid damaging the
coating.
self-adhesive
strip
SG20
GD2C
