E_MH_Installation_instructions_Skylux_Climax
20/11/2020
72/88
Tie bar for saddle roof
PREPARATION
To guarantee the stability of the saddle roof, a tie bar must be installed for every 2 supports. With a non-thermal
bridge Climax saddle roof, you must also use a tie bar set at the open end.
An eye bolt must be installed in these supports at the gutter side during the preparation phase. Drill a hole (Ø 10
mm) at 60 mm from the end of the (side) support. The eye bolt must be fixed on the inside of the (side) support
profile (D1 or D2) with a bolt (M10). Repeat every 2 supports.
See the specific installation tips for the Climax single-pitch roof in this manual for information on the assembly of
the gutter, posts and (side) supports. Non-thermal, pages 21-41 and thermal, pages 42-67.
ASSEMBLY
60 mm
8426
8424
ZSG (4x)
M10 x 30
M10
The tie bar must be installed when all supports have
been installed and before you install the glazing.
Screw the ridge fixing to the bottom side of the ridge
between 2 supports using an eye bolt. Fasten the ridge
fixings to the ridge using screws (ZSG).
Install the threaded bar ends to the eye bolts using the
stainless steel bolts (M10 x 30 mm) and the safety nuts
(M10).
