Skymsen PAIE, Instruction Manual

08

Picture - 05

A

B

3.   Operation

3.1  Starting

                                    IMPORTANT 

Unplug  the  machine  before  to  change  the  discs  or  the  grilles.
Wait  till  the  disc  is  completely  still  ,  before  to  open  the  frame  lid  .

Before starting be assured the frame lid is surely closed and locked .
To start the machine press the ON/OFF switch green button , on the machine 

right side .

The Food Processor Model PAIE has two safety devices :
One of them is meant to avoid the machine to start with an open lid , and 

therefore to guaranty the operator safety , it shall not be used to switch OFF the machine 
, rising the lid .When the frame lid is lowered the machine starts automatically .

The other safety device switch OFF the machine when the Ram Feed Arm is 

lifted , the machine will run again when the Ram Feed Arm is lowered .

3.2 Using One Disc

                                       IMPORTANT
The Expeller Dish shall always be on place , independently of the disc or 
grille currently in use . Before to open the frame lid , be assured the disc 
is completely still .

17

IMPORTANT

Carefully read ALL INSTRUCTIONS of this manual before turning the machine 
ON.   Be sure to be familiar with the set and that you have well understood all 
information contained in this manual.   If you have any question contact your 
supervisor or your nearest Dealer.

4.2.1 Danger

An electric cable or electric wire with damaged insulation could cause electrical 

shocks as well as electrical leak.  Before use check conditions of all wires and cables.

4.2.2 Advices

Be sure ALL  INSTRUCTIONS in this manual have been thoroughly 

understood.  Every function and operational procedure have to be very clear to the 
operator.  

Any manual command ( switch, button or lever ) shall be given only after to be 

sure it is the correct one .

4.2.3 Precautions

The electric cable has to be compatible with the power required by the 

machine,
  Cables touching the floor or close to the machine need to be protected against short 
circuits.

Oil reservoirs if any have to be full up to the required level as indicated.  Check 

level and add oil if necessary.

4.3 Routine Inspection

4.3.1 Advice

When checking the tension of the  belts or chains,  DO NOT introduce your 

fingers between the belts , the chains, nor the gears.

4.2 Safety Procedures and Notes Before Turning Machine ON