165
Nynja Build Manual 1.4d
The sensor for this is actually the CHT sensor from the front port cylinder head.
Unscrew this and screw it into the water temperature fitting, using a touch of
sealant on the threads. Note that the fitting is supplied as part of the instrument
package option
– not the main kit.
Figure 216 water temperature sensor.
Note
– cylinder heads on 912UL and ULS engines manufactured after early
2013 now have ‘wet’ CHT senders, and thus read coolant temp direct form
the Cylinder head, and no additional coolant temp measuring is required
–
and the above is all non applicable. See rotax service bulletinSB-912-066
f) Refit the hoses.
The hoses may have to be repositioned slightly to effect
maximum rotation of the expansion tank
.
g) Fit the rubber elbow on the port water pipe assembly to the expansion tank,
passing between the carburettor and the upper engine mounting plate.
Trial fit the inlet manifold and carburettor to check the positioning of the rubber
elbow. The elbow may touch the engine mounting plate. In this case position an
additional piece of rubber hosing to prevent wear.
h) When satisfied with the positioning, refit the manifold using a torque setting of
10Nm (1kgm, 7ftlb) on the 6mm diameter bolts.
i) The intake manifold balancing tube, crossing the engine in front of the
carburettors, must be curved forward more than its standard position to allow
more room for the expansion tank in its new position.
Figure 217 expansion tank and rubber elbow.
Summary of Contents for Nynja
