www.skyrc.com
- 12 -
SERVO TESTER
SERVO TESTER
Servo 1
Servo n...
Reciver
Battery
Pack
W A T T M E T E R
C U R R E N T : 3 5 . 1 1 A
P E A K ( C ) : 5 2 . 1 1 A
V O L T A G E : 2 5 . 1 3 V
W A T T A G E : 8 8 2 . 3 1 W
P E A K ( W ) : 1 3 0 9 . 2 W
E n e r g y : 8 2 W h
C h a r g e : 3 . 2 A h
Receiver & Servo Testing
Servo testers are very useful for exercising your servos and Electronic
Speed Control (ESC) without the need to turn on your transmitter, and
you do not even need your receiver. The servo tester will put out a
signal just like the signals normally sent by your receiver to the servos
or ESC. The dial knob on the servo tester will change the signal just
like moving your transmitter stick would change the signal going to a
servo or ESC.
To use the tester to evaluate a servo
Connecting a battery to the i-Meter volt port. Plug a servo into the
servo port. The servo can be controlled with the adjustment dial under
Manual Mode. Press ‘MODE’ button once to set the PPM signal to auto.
The servo tester will use 1520us as centre and automatically output
cycling signal to move the servo arm back and forward.
