Skyrc Quattro B6AC, Instruction Manual

Never

attempt

to

charge

or

discharge

the

following

types

of

batteries

:

A battery pack which consists of different types of cells 
(including different manufacturers)
A battery that is already fully charged or just slightly discharged
Non-rechargeable batteries (pose an explosion hazard)
Batteries that require a different charge technique from NiCd, NiMh, LiPo or gel cell 
(Pb, lead-acid battery)
A faulty or damaged battery
A battery fitted with an integral charge circuit or a protection circuit
Batteries installed in a device or which are electrically linked to other components
Batteries that are not expressly stated by the manufacturer to be suitable for the 
currents the charger delivers during the charge process

WARNING

AND

SAFETY

NOTES

WARNING

AND

SAFETY

NOTES

The

allowable

DC input

voltage

is 11-18V

DC

.

The

allowable

AC input

voltage

is

100-240V AC

.

These warnings and safety notes are particularly important. Please follow the instructions 
for maximum safety; otherwise the charger and the battery can be damaged or at worst it 
can cause a fire.

Never  leave  the  charger  unattended  when  it  is  connected  to  its  power  supply.  If  any 
malfunction  is  found,  TERMINATE  THE  PROCESS  AT  ONCE  and  refer  to  the 
operation manual.

Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration. 
Never drop it.

This  charger  and  the  battery  should  be  put  on  a  heat-resistant,  non-flammable  and 
non-conductive  surface.  Never  place  them  on  a  car  seat,  carpet  or  similar  surface. 
Keep all flammable volatile materials away from the operating area.

Make  sure  you  know  the  specifications  of  the  battery  to  be  charged  or  discharged  to 
ensure  it  meets  the  requirements  of  this  charger.  If  the  program  is  set  up  incorrectly, 
the  battery  and  charger  may  be  damaged.  Fire  or  explosion  can  occur  due  to 
overcharging. This warranty is not valid for any damage or subsequent damage arising 
as a result of a misuse or failure to observe the procedures outlined in this manual. 

To avoid short circuiting between the charge lead, always connect the charge cable to 
the charger first, then connect the battery. Reverse the sequence when disconnecting.