2)Manual Programming
Manual Programming TORO 8 is as simple as answering a few questions. The
TORO 8 asks questing by beeping a setting number, followed by the possible
setting values. There are nine settings that can be programmed in the TORO 8.
You must answer yes or no to the setting values as they are presented by TORO 8.
When you enter programming mode the ESC will emit a sequence of beeps and LED
flashes that tell you which programming step you are in. There are two parts to the
beep sequence. The first set of beeps indicates the 'Setting Number (Question), e.g.
Brake/Reverse Type, and the second set of beeps indicates a Setting Value, e.g.
Reverse Lockout. Answering "No" to a Setting value will cause the ESC to ask for
the next value in that section. After a "Yes" answer is accepted, the ESC knows you
aren't interested in any other option in that section, so it skips to the first option in the
next section.
"
"
"
"
Note: If you answer "no" to all Setting Values for a particular Setting Number, the ESC
will keep whatever value had been previously programmed. Only by answering "Yes" to
a Setting Value will the ESC store/change that value.
5/8
6/8
Plug Battery into the TORO 8
Hold full throttle on your transmitter
Turn the ESC switch ON
TORO 8 flashes LED and rings once
Wait few seconds.
TORO 8 flashes LED and rings 1 second indicating that it is ready for CALIBRATION mode
Continue to hold full throttle
TORO 8 flashes LED while beeping
Wait another few seconds
TORO 8 flashes LED and rings 1 second
TORO 8 flashes LED while beeping indication that you are in PROGRAMMING mode
Let trigger go neutral (Centre)
At this point the TORO 8 will be flashing/beeping the following sequence:
Beep-Pause-Beep... and then repeats
This indicates that you are at Question 1 and it is asking to accept/reject value 1.
Programmable Features
Question (Setting)
How to Enter Programming Mode
Ver. 1.1
Ver. 1.1
1)Reverse Lockout(D)*
2)50%(D)*
2)50%(D)*
5)Disable(D)*
1)Disable(D)*
2)Normal(D)*
2)Auto-Lipo(D)*
2)Normal(D)*
1)Brushless(D)*
Note: Factory Defaults are indicated by asterisk (D)*
1)Large
3)Small
4)Very Small
5)Smallest
