1. Replacing your Grumblies™ with fresh batteries will resolve
most troubleshooting issues. If problems continue, please reach
out to our customer service department:
customerservice@skyrocketon.com.
Have an adult install 3 fresh AA batteries.To insert or
change batteries, turn Grumblies™ upside down, and twist
screwdriver to left to remove hardcover battery door.
• Recommend using only fresh alkaline batteries of the
required size and recommended type.
• Do not mix old and new batteries, different types of
batteries [standard (Carbon-Zinc), Alkaline or
rechargeable] or rechargeable batteries of different
capacities.
• Remove rechargeable batteries from the toy before
recharging them.
• Rechargeable batteries are only to be charged
under adult supervision.
• Please respect the correct polarity, (+) and (-).
• Do not try to recharge non-rechargeable batteries.
• Do not dispose of batteries into fire.
• Replace all batteries of the same type/brand at the
same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults.
• Batteries should be recycled or disposed of as per state
and local guidelines.
• Remove batteries when storing toy.
- Do not immerse Grumblies
TM
in water or any other form of liquid.
- Do not throw or kick Grumblies
TM
as this may damage
mechanical functionality.
- Do not leave Grumblies
TM
in extreme heat or freezing
temperatures, as this can result in permanent
mechanical damage.
- Surface wipe clean with a damp cloth and keep moisture
away from battery compartment.
© 2018 Skyrocket LLC, Los Angeles, CA 90066 USA. All rights reserved.
Grumblies and Skyrocket and their respective logos are trademarks and/or
registered trademarks of Skyrocket LLC. All other trademarks, logos and
copyrights are the property of their respective owners, and there is no
relationship express or implied with Skyrocket LLC
.
Questions or comments? Please call 888-674-5650 or visit www.grumbliesmeltdown.com
Product colors and styles may vary from those shown. Retain this package for future
reference.
MADE IN CHINA
PATENT PENDING
This device is marked with the selective sorting symbol on waste electrical
and electronic equipment. This means that this product should be supported
by a selective collection system accordance with applicable regulations in
order to be either recycled or dismantled in order to reduce any impact on
the environment. The batteries, submitted to a specific collection system, must be
removed from the product and disposed of separately. When that the batteries are
not to be extracted, the product must be delivered to and appropriate collection
center for recycling is complete. Electrical and electronic products as well as
batteries that have not been sorted before disposal are potentially dangerous for the
environment and human health due to the presence of hazardous substances. For
more information, contact your local or regional government.
TROUBLESHOOTING:
FCC STATEMENT
BATTERY INFO
IMPORTANT BATTERY INFO:
PRODUCT CARE
(Included)
3x
AA (R6) 1.5V
AA
AA
AA
NOTE: Remove “Try Me” pull tab before use.
US - G2
This device complies with PART 15 of the FCC Rules. Operation is
subject to the following two conditions. (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
•
CAUTION: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
•
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures: Reorient or relocate the receiving antenna - Increase the
separation between the equipment and receiver - Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected - Consult the dealer or an experienced
radio/TV technician for help.
