Accommodates 2 AAA size batteries.
7.
BATTERY DOOR
8.
WALL MOUNT HOLDER:
Supports the transmitter in wall mounting.
9.
FOLDING TABLE STAND
BEFORE YOU BEGIN
TRANSMITTER:
1. Remove the transmitter from the stand and unscrew the battery door of the transmitter.
2. Insert 2 x AAA batteries into the battery compartment. Be sure to insert them according to the
polarity infor/- in the battery compartment.
3. The receiver can receive humidity and temperature data from up to 3 transmitters. Assign the
channel to each transmitter, Channel 1, 2 or 3 respectively by sliding the switch inside the battery
compartment.
4. Press the reset key of the transmitter individually by a pin to confirm the channel setting.
5. Slide the °C/°F switch inside the battery compartment for centigrade or Fahrenheit.
6. Screw the battery door back into place..
NOTE:
1. Once the channel is assigned to a transmitter, you can only change it by removing the batteries or
resetting the unit.
2. Avoid placing the transmitter in direct sunlight, rain or snow.
WEATHER STATION:
1. Remove the battery door and insert 3 x AA batteries into the battery compartment according to
the polarity infor/- in the battery compartment.
2. Replace the battery door.
