2) Remove the protective strip from one side of the
tape. Adhere the tape to the designated area on the
back of the mounting bracket.
3) Remove the protective strip from the other side of the
tape. Position the Outdoor Temperature transmitter
in the desired location, ensuring that the Skyscan
Atomic Clock can receive the signal.
TROUBLESHOOTING
Problem:
The LCD is faint.
Solution:
1) Replace the batteries.
Problem:
No reception of WWVB signal
Solution:
1) It may help reception to face
the front of the Atomic Clock
in the general direction of Ft.
Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the Skyscan
Atomic
Clock is at least 6 feet (2
meters) from any electrical
devices, i.e. TV sets,
computers, or other radio
controlled clocks.
4) Remove batteries for five
minutes, reinsert and leave
the unit alone overnight
without pressing any keys.
Problem:
Hour is incorrect (minute and
date are correct).
Solution:
1) Be sure the correct time zone
and daylight saving time are
selected.
Problem:
"OFL“ appears in the indoor
temperature section of the LCD
Solution:
1) Move the Skyscan Atomic
Clock to an area with
warmer or cooler
surrounding temperature.
Current surrounding
temperatures are outside
measuring range.
Problem:
"--.-" appears in the outdoor
temperature section of the LCD.
Solution:
1) Remove the batteries of both
units for one minute, then
reinsert them again. Make
sure the batteries are new
and fresh.
2) Move the Atomic Clock closer
to the transmitter or place the
transmitter closer to the
Skyscan
Atomic Clock. Make
sure the clock is at a
receivable range from the
transmitter.
3) Move the units to another
location. Interferences from
other electrical devices
operating on the same signal
frequency (433MHz) may
prevent correct signal
transmission and reception.
Problem:
"OFL“ appears in the outdoor
temperature section of the LCD.
Solution:
1) Wait until the current
surrounding temperature
cools down or increases.
Current temperature is
outside of the measuring
range of the transmitter. The
outdoor temperature will be
displayed again once the
current surrounding
temperature is within the
range of the transmitter.
CARE AND MAINTENANCE
:
•
Avoid placing the units in areas prone to vibration
and shock as these may cause damage.
•
Avoid areas where the units can be exposed to
sudden changes in temperature, i.e. direct sunlight,
extreme cold and wet/moist conditions as these will
lead to rapid changes which reduces the accuracy of
readings.
•
When cleaning the LCD and casing, use a soft damp
cloth only. Do not use solvents or scouring agents.
•
Do not submerge the units into water.
•
Immediately remove all low powered batteries to
avoid leakage and damage. Replace only with new
batteries of the recommended size.
•
Do not make any repairs to the units. Please return it
to the original point of purchase. Opening and
tampering with the units may invalidate the warranty.
SPECIFICATIONS:
Temperature measuring range
Indoor: +32ºF to +122ºF with 0.2ºF resolution