Skytech: 5320
REV. 7-25-18 Page 4
SETTING THE COUNTDOWN TIMER
This remote control system can operate with a built-in countdown timer when the
transmitter is in the ON or THERMO modes (THERMO or ON must be displayed on the
screen).
1. Touch the word TIMER on the LCD screen of the transmitter for more than two
seconds on the transmitter. The minimum 0:15 minute setting on the will begin to
flash.
2. Press the UP or DOWN button on the transmitter to begin advancing through
each of the countdown time options. Available countdown times are 15 minutes,
30 minutes, 45 minutes, 1 hour, 1 hour 30 minutes, 2 hours, 2 hours 30 minutes,
and each additional half-hour up to nine hours.
3. To set the TIMER press the MODE/SET button on the transmitter if the system is
ON. It will remain on until the time has expired. If the system is in the THERMO
mode, it will cycle ON and OFF, as the room temperature requires until the “time”
has expired.
OPERATIONAL NOTE
: When the timer is used in the THERMO mode, the THERMO
operation will discontinue when the “time” has expired. System will return to the
THERMO OFF position.
PM
ROOM
SET
TIMER
ON
ON
LOW/BATTERY INDICATOR
The battery ICON on the right side of the LCD screen will appear when battery power
has dropped significantly. At this time, approximately two weeks of battery power
remains until the transmitter may experience partial or complete loss of functions.
PM
ROOM
SET
TIMER
OFF
ON
CHILDPROOF “LOCK-OUT” – (CP)
This remote control includes a CHILDPROOF “LOCK-OUT” feature that allows the
user to “LOCK-OUT” operation of the appliance from the TRANSMITTER.
SETTING “LOCK-OUT” – (CP)
1. To activate the “LOCK-OUT” feature, press and hold the UP button and
touch the word TIMER on the LCD screen of the transmitter together, for
5 seconds. The lock icon will appear on the LCD screen.
2. To disengage the “LOCK-OUT”, press and hold the UP button and
touch the word TIMER on the LCD screen of the transmitter together for
5 seconds or more, and the lock icon will disappear from the LCD screen
and the transmitter will return to its normal operating condition.
NOTE:
If the appliance is already operating in the ON or THERMO MODES,
engaging the “LOCK-OUT” will not cancel the operating MODE. Engaging the
“LOCK-OUT” prevents only the manual operation of the TRANSMITTER. If in
the auto modes, the THERMO operation will continue to operate normally. To
totally “LOCK-OUT” the operation of the TRANSMITTER’S operating signals;
the transmitter’s MODE must be set to OFF.
PM
ROOM
SET
TIMER
OFF
ON
THERMO
AM
