Skytech: TM-R-2A
REV. 10-12-18 Page 2
WALL MOUNTING THE TIMER
1. Remove face from backing plate by insetting a small screwdriver into
the small slot at the top or bottom of the faceplate as shown to the right
then snap OFF.
2. Locate the (2) two mounting holes and mark the holes on the wall.
3. Use the (2) two dry wall anchors and screws (that are supplied) to
mount the base plate to the wall as shown.
4. The wall transmitter can also be mounted onto an existing (Plastic)
electrical box.
5. Base plate should be mounted level on the wall for best operation.
WALL
3V
3V
30
60
120
OFF
RECEIVER
The remote receiver operates on 4 AA-size 1.5V
batteries. It is recommended that ALKALINE
batteries be used for longer battery life and max-
i-
mum microprocessor performance. IMPORTANT: New
or fully charged batteries are essential for proper
operation of the remote receiver.
The remote receiver houses the microprocessor that
responds to commands from the transmitter to control
system
operation. The remote receiver has a 3-position slide
switch for selecting the MODE of operation:
ON/REMOTE/OFF
1. With the slide switch in the ON position (toward the LEARN button), the system will remain ON until the slide switch
is placed in the OFF or REMOTE position.
2. With the slide switch in the REMOTE position (centered), the system will only operate if the remote receiver receives
commands from the transmitter.
3. With the slide switch in the OFF position (away from the LEARN button), the system is OFF.
4. It is suggested that the slide switch be placed in the OFF position if you will be away from your home for an extended
period of time. If the remote receiver is mounted out of children’s reach, placing the slide switch in the OFF position
also functions as a safety “lock-out” by both turning the system OFF and rendering the remote receiver inoperative.
REMOTE
ON
OFF
LEARN
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Remote Receiver
Batt
ery c
over
slide
s on
/off
Slide
Switch
ON
REMOTE
OFF
NOTE:
This product is designed for use with an attended hearth appliance or fire feature. Adults must be present when
the Control System is operating. DO NOT program or thermostatically set this Control to operate a hearth appliance
or fire feature when Adults are not physically present. Furthermore, DO NOT leave the hearth appliance or fire feature
burning unattended; it may cause damage or serious injury. If an Adult is going to be away from the hearth appliance or
fire feature for any length of time, then the handheld/wall mount, receiver/control module and application should be in the
“OFF” position
This remote control system must be installed exactly as outlined in these instructions. Read all instructions
completely before attempting installation. Follow instructions carefully during installation. Any modifications of the
SKYTECH remote control or any of its components will void the warrant and may be pose a fire hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance
manufacturer’s instructions and wiring schematics for proper placement of all wires. All electronic modules are to be
wired to manufacturer’s specifications.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/
or electronic module for correct wiring procedures. Improper installation of electric components can cause damage to
electronic module, gas valve and remote receiver.
WARNING
