Page 41
CN - 14
PIN NO.
CN1
CN13
OHM
CN - 1
WIRE COLOR
CN - 14
PIN NO.
CN - 1
WIRE COLOR
Red/White
White
Black
Red
White/Red
Yellow
Brown
White/Brown
Blue/White
Orange
White/Orange
Gray
White/Gray
White/Yellow
Purple/White
Black/White
Purple
White/Purple
Blue/Green
Brown/White
Blue/Purple
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Figure 6-13. LED Test
d. Wiring Harness Test
The following test checks the wires leading from
the relay box connector to the 24 pin connector
table socket. These wires apply low voltage to the
pendant control buttons.
1. Activate the AC120V operating mode.
2. Disconnect the pendant control from the
table base connector. All other connectors should
be connected.
3. Use a DC voltmeter and measure the
following pins located in the 24 pin table base
connector CN13. See figure 6-14.
NOTE
•A fine wire or a paper clip may be
needed to accurately test the small
sockets in the connector. The connec-
tor is low voltage and there is no danger
of electrical shock.
•Pin 19 will have no voltage potential
unless one of the return-to-level micro-
switches are activated.
6002B
c. LED Test
The BATTERY and AC120V power ON indicators
can be checked with an LED tester. Test BAT-
TERY indicator at pin 1(+) and pin 2(-) of 24 pin
Pendant Control connector. Test AC120V indica-
tor at pin 1(+) and pin 3(-). See figure 6-12.
If no LED tester is available the LEDs can be tested
by applying 5 volts to the appropriate pins. To
avoid damage to the LED a 330 ohm resistor must
be placed between the power source and the
connector pins. See figure 6 -13.
Figure 6-14. Table Base Connector
e. Test Results:
If you do not receive the correct voltage reading,
the wiring or connector pins may be faulty. Discon-
nect connector CN1 from the Relay Box and using
an ohmmeter, test the continuity between the cor-
responding pins in connectors CN1 and CN13.
See figure 6-15. If the correct readings are ob-
tained, this part of the circuit is okay and the
problem may be the relay box.
Figure 6-15. Base Connector Continuity Test
Summary of Contents for ELITE 6002
