Page 46
b. CN4 to CN12 Test
1. Disconnect connectors CN4 and CN12.
Leave all other connectors connected.
2. Using an ohmmeter, test for continuity
between pins 3 and 4 of CN4 and pins 1 and 2 of
CN12. See figure 6-22.
OHM
CN11
7
6
5
1
2
3
CN-11
1
2
5
6
4
4
0
0
0
CN-4
CN4
CN-51
CN51
OHMS
5
6
4
2
3 1
4
CN12
7
6
5
1
2
3
CN4
4
OHM
CN-4
3
4
1
2
0
0
CN-12
OHMS
2
1
OHM
7
6
5
CN4
(+)
(-)
1
2
3
4
6-10. Main Wire Harness Continuity Tests
If correct meter readings are not received in tests
between components, before replacing the com-
ponents, test the Main Wire Harness to be sure all
connectors and wires are making a good connec-
tion.
a. CN4 to Batteries Test
1. Disconnect connectors CN4 and the (+) and
(-) connectors from the batteries. Leave all other
connectors connected.
2. Using an ohmmeter, test for continuity
between pin 1 of CN4 and battery (+) connector.
Also test between pin 2 of CN4 and battery (-)
connector. See figure 6-21.
NOTE
The 15 amp battery protection fuse is in
the line between CN4 pin 1 and the
battery connector. Test the continuity
of the fuse if correct meter reading is not
received.
Figure 6-21.
6002B
Figure 6-22.
c. CN4 to Charging Box Test
1. Disconnect connectors CN4, CN11 and
CN51. Leave all other connectors connected.
2. Using an ohmmeter, test for continuity
between pins 4, 5 and 6 of CN4, pins 1 and 2 of
CN11, and pin 4 of CN51. See figure 6-23.
Figure 6-23. CN4, CN11, and CN51
Summary of Contents for ELITE 6002
