15
Operator’s Manual -
Model
NXG-3250-DS
TV I
nsTallaTIon
& C
onneCTIons
|
Top Mounting
WARNING: Use at least two people when transporting the TV.
Note: If you mount the TV to a ceiling or wall mount, it is best to install the Detachable Speaker Bar before the TV has been
installed.
Tools Needed: Phillips Screwdriver
1. Remove the (4) #8-32 Phillips Head screws in either the top or bottom mount position.
(Refer to Figure 1 below for proper screw removal)
2. Position the Speaker bar in place and secure with the same (4) #8-32 screws that were removed in step 1.
3. Screw securely
4. Loosen the 3 latches, and open the Component Cover.
5. Take the Speaker Bar Cable from the speaker, making sure that the Speaker Bar
Cable Wire is placed on the Rubber Sealing Gasket, and connect at top left of
Component Housing (Refer to Figure A at right)
6. When you close the Component Cover, be sure that the Speaker Bar Cable Wire is
placed over the Rubber Sealing Gasket. As with all wires entering the connection
compartment, leave a drip loop as the wire enters the TV, this will allow water to drip
from the bottom of the loop.
SPEAKER BAR
Do Not
Remove
Figure 1
Figure A
