3. Note: This step requires two persons. During this
step, you will connect the four assembled leg sections
Stand two leg sections and hold them in the positions
shown. Insert the small end of the Top Tube into the
indicated Top Tube with “T”-Joint (1) on the other leg sec-
tion. Repeat this step until all four leg sections are con-
nected. When this step is completed, the frame will be
fully assembled and freestanding.
4. Lay the Bed (Mat) (3) on the ground inside the assem-
bled frame. Make sure that the two warning decals (not
shown) are on top of the Bed (Mat). (Not Shown.)
Note: If you purchased the Skywalker Trampoline
Combo, the enclosure was pre-installed on the Bed (Mat)
(3) at the factory. Inspect the attachments of the enclosure
Netting to the trampoline mat (bed). Make certain each of
the V-rings on the trampoline mat (bed) is threaded
through the corresponding “buttonhole” in the Netting.
Be sure the opening in the Netting faces one of the “T”-
Joints. If you did not purchase a Trampoline enclosure,
disregard this paragraph.
Note: There are 56 V-rings around the edge of the Bed
(Mat) (3) and 56 holes around the top of the frame. In
Steps 4 and 5 you will attach the Bed (Mat) (3) to the
frame, using 56 Springs (4).
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful where you place your
hands as the Springs and frame joints can pinch.
12
2
Small
End
1
“T”-Joint
V-rings
“T”-joint
opening faces
“T”-joint
