IDP 100 Modem Series - Developer Guide
©
SkyWave Proprietary 37 T203, Version 04
5.4.19 S90, S91, S92
– Capture Trace Define
Description
This command set configures a trace class and subclass. Once class and subclass are
configured, the trace tables are searched for the most recent match trace record. If a
match is found, the trace record is copied to the captured report.
The captured report can then be obtained by reading S93…S123 (when the Result
Code is OK).
Syntax
ATS90=n S91=m S92=p
See Table 10 for other command formats
Parameters
n
– Trace record class (Table 17)
m
– Trace record subclass (Table 17)
p
– 1 to trigger a trace record capture
Information Response Syntax
None
Result Codes
OK
Success
ERROR
Example
The trace tables are searched for a satellite status general event (Class 3,
Subclass 1). The OK response indicates that a trace record was found and moved
to the capture record.
ATS90=3 S91=1 S92=1
OK
The following command attempts to capture a trace record for a satellite event.
The ERROR response indicates that there is no matching trace record in the logs.
ATS90=3 S91=1 S92=1
ERROR
Trace log information can also be obtained via %EVNT. When the value 1 is
written to S92, the most recent trace log information corresponding to the class
specified in S90 and subclass specified in S91, is captured in S93...S123. The AT
command result code is
OK
if the trace log information was successfully
captured (i.e., trace log information corresponding to the specified class and
subclass existed), or
ERROR
otherwise.
Summary of Contents for IDP 100 Series
Page 106: ...www SkyWave com ...