Source Lighting by CAST
1120-A Goffle Road
Hawthorne, NJ 07506
Ph: (973) 423-2303 Fax: (973) 423-2304
Email: info@cast-lighting.com
IMPORTANT SAFETY INSTRUCTIONS:
•Please read carefully before installing. Save these
instructions.
•Consult with a qualified electrical contractor and local
electrical codes before installing any electrical product.
•Clean fixture with mild soap. Do not use acid or any other
solvent-based cleaner.
•Do not submerse fixture in water.
•All fixtures must be installed 10 feet (3.05m) away from a
pool, spa, or fountain.
•Use fixture with low-voltage outdoor lighting system only.
DO NOT OVERLOAD LOW VOLTAGE CABLE or
TRANSFORMER.
ASSEMBLY INSTRUCTIONS:
Your fixture is ready to be
connected using your preferred wiring method right out of
the box.
LUMEN ADJUSTMENT:
The SBML Series has four lumen
setting options numbered 1, 2, 3, 4, which are the equivalent
of legacy halogen 10W, 20W, 30W, and 35W fixtures. Simply
loosen the thumb set screw of the light engine/shroud, using
a small 3/16” flat head screwdriver, and select the lumen
output level by turning the arrow dial. Fixture is factory set at
the highest level (#4). See chart on page two for information
on fixture performance.
INSTALLATION/MOUNTING INSTRUCTIONS:
Note:
We recommend, when installing any low-voltage fixture,
that you have the following:
Voltage Meter, Wire Nuts, Amp
Probe, Basic Hand Tools for Adjustment.
INSTALLATION/MOUNTING & WIRING STEPS:
1. To prevent electrical shock, disconnect
transformer from electrical supply before
service.
2. Fixture is provided with Set-N-Stake® quick link
composite with brass insert stake mount and
allen key.
3. Place/set fixture in desired location. Place
stake in pre-dug hole, compact/backfill soil leaving
approximately 1” exposed above grade.
4. Run wire lead to the desired connection point with the
main wire lead running to the transformer, keeping most of
the excess wire at the fixture. Bury excess wire directly at
the base of the fixture.
5. Cut wire lead as needed, while leaving enough extra wire to
move fixture.
6. Connect fixture wire lead to main wire lead from the
transformer using desired wire connection suitable for
underground burial or wet location. Use underground low-
energy cable.
7. Use allen key to adjust the knuckle of the fixture aiming at
the center of the object you are illuminating.
WARNING: INSTRUCTIONS PERTAINING
TO A RISK OF FIRE, OR INJURY TO PERSONS:
•Lighted lamp is HOT. Lamp is hot when illuminated; do not
touch when lamp is on.
•Turn off/unplug electrical power before modifying the
lighting system.
•Allow fixture to cool before touching or replacing optics.
•Lamps get HOT quickly! Contact only switch/plug when
turning on.
•Do not touch hot lens, guard, or enclosure.
•Keep away from potential flammable materials, structures,
and/or landscapes.
•Do not operate fixture if cover, fitting, and/or shield is
damaged or missing.
SERVICE INSTRUCTIONS:
To prevent electrical shock, disconnect transformer from
electrical supply before service, allow luminaires to cool.
For Questions on how to obtain the proper cable or connectors, call (973) 423-2303 | www.cast-lighting.com
SBML SERIES: Multi Lumen Spotlight with Field Changeable Optics
Lumen Adjustment
Knob
