10
LED Display
Select the
, press the ENTER button and the display will blink. Use the DOWN and UP
button to select
(
LED display on
)
or
(
LED display off 20 seconds after exit
menu
)
. Once select, press ENTER button to setup or exit menu mode without any change after one
minute. Back to the functions without any change press MENU button again.
Temperature
Select the
, press the ENTER button and the display will show the current running
temperature of the fixture. To go back to the functions press the MENU button again.
Fixture Hours
Select the
, press the ENTER button and the display will show the running time of the
fixture. To go back to the functions press the MENU button.
Firmware version
Select the
, press the ENTER button and the display will show the version of software of
the fixture. To go back to the functions press the MENU button again.
6. HOW TO CONTROL THE UNIT
You can operate the unit by DMX controller:
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be affected at once. Every time you turn the unit on, it will show
on the display. After
that the unit will be ready to receive DMX signal or run the built in programs
.
6.1 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512
channel so that the units can receive DMX signal.
Press the MENU button up to when the
is showing on the display. Pressing ENTER button