14
used.
8. TROUBLESHOOTING
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
Problem
Possible Cause
Action
The unit does not work, no light. Incorrect power cable
connection.
Check the connection of power.
Incorrect mains voltage.
Measure the mains voltage
on the main connector.
The unit does not respond
properly to the DMX control.
Incorrect DMX cable
connection.
Check DMX connectors and
cables to see if link properly.
Repair or replace damaged wires.
Incorrect address assignment to
the units.
Check the addresses of the units
and the protocol settings.
Unfinished data connection.
Insert a terminal plug in the
output jack of the last unit of the
connection.
It has been set up an operating
mode different from the DMX
mode used.
Check the operating mode set up.
Try to use another DMX
controller.
