1
2
MEDIATELY.
Check to make sure all wires are routed clean and are inserted thoroughly
into the provided split loom. Check for any possible areas where the wires
or split loom can rub or chafe over time causing a short.
Next install the 30 amp fuse in the red 12V wire from the SledStart mod-
ule to the positive terminal of the battery.
STEP 13
Install the AAA battery into the LCD remote be unlocking the battery door
with the slide lock on the back of the remote. Once the battery is installed
a self-test of all the icons will be performed along with a single beep from
the remote. Reinstall the battery cover and lock it with the slide lock.
NOTE: The violet wire on the SledStart Module is only to be used with
the Yamaheater Hot Hands Controller. For more information or to order the
Yamaheater, please visit our website www.sledstart.com or e-mail us at
support@sledstart.com. For a user manual on how to operate SledStart
and Yamaheater together please e-mail us at support@sledstart.com.
C
C
C
C
C
ODE
ODE
ODE
ODE
ODE
M
M
M
M
M
ATCHING
ATCHING
ATCHING
ATCHING
ATCHING
B
B
B
B
B
ETWEEN
ETWEEN
ETWEEN
ETWEEN
ETWEEN
R
R
R
R
R
EMOTE
EMOTE
EMOTE
EMOTE
EMOTE
C
C
C
C
C
ONTROLS
ONTROLS
ONTROLS
ONTROLS
ONTROLS
A
A
A
A
A
ND
ND
ND
ND
ND
M
M
M
M
M
ODULE
ODULE
ODULE
ODULE
ODULE
Code matching between remote control and SledStart module may be nec-
essary prior to use. To test, press the "X" button on the LCD remote. If
the remote and SledStart module are matched you will hear a 3-note mu-
sic tone along with the module temperature in Celsius on the LCD dis-
play. If the module and remote are not matched you will hear 2 beeps
and you will not see the temperature show up on the LCD display. If code
matching is necessary, follow the steps below to code match the remote
controls to the SledStart module. If code matching is not necessary please
proceed to page 14 "SAFETY TESTING THE SYSTEM".
STEP 1
Quickly cycle the ignition on/off five times. The module should enter code-
matching mode. The headlight will flash along with audible clicking from
the module.
STEP 2
As the module is clicking and the headlights are flashing, press and re-
lease the "T" button, then press and release the "S" button on the remote
