1
5
NOTES ABOUT PROGRAMMING MODE
ALL programming must be done with the 2-way LCD remote. The one
way remote can not be used for programming.
If no buttons are pressed for thirty seconds during programming mode,
the system will exit programming.
After selecting and confirming any setting with the "S" button, you will
automatically exit programming.
To re-enter programming mode, press the
button for two seconds,
and programming will resume at the point where you last exited. The
button will also scroll to the desired feature.
At any time to exit programming without saving changes, press the
"X" button, or
to move to next selection. Changes will only be con-
firmed with the "S" button.
Replacing the AAA battery within 3 second of removal will retain all
of your previous custom settings.
PART ONE
To enter programming mode, press
for two seconds. You will hear a
single beep to confirm activation of programming mode. Remember…once
you confirm any setting with the "S" button you will exit programming. You
must Press the
button again for 2 seconds to re-enter the program-
ming mode.
Once in programming, press
repeatedly until the icon for your desired
function is flashing. When your desired icon is flashing, follow the steps
for each of the following sections:
Sound
- Press "S" to activate LCD sound. The
icon will remain lit
when sound is selected.
Vibrate
- Press "S" to activate LCD vibration instead of sound. The
icon will remain lit when this option is selected.
Backlight
- Press "S" to activate LCD backlight. The
icon will
remain lit when this option is selected. To deactivate, re-enter program-
ming mode, if necessary scroll with the
button until the
icon
is flashing and press "X".
Temperature Auto-Start
- Press "T" to scroll to the desired temperature
at which the system starts the snowmobile. Selections are from -40
O
F to
