18
Feature 2 - Timer Mode Interval
This feature sets the interval between Timer Mode starts. Option settings
are 1 = every hour, 2 = every two hours, and 3 = every three hours. To
activate Timer Mode, press "T". The
icon will appear on LCD screen
and the snowmobile will start and run its first cycle. To deactivate Timer
Mode, press "T" again and the
icon will disappear from the LCD
screen canceling Timer Mode. Timer Mode will run for a total of 24 hours.
Option 1 = 24 cycles, 2 = 12 cycles, and 3 = 8 cycles. Engine run time
will be determined by the option selected in Feature 1,
see chart on page
17.
Feature 3 - Turbo Mode Run Time/Valet Mode
This feature will allow cool down for turbo units or can be used as a valet
mode. To activate Turbo Mode, press
twice. To deactivate Turbo Mode,
press
twice again. Wait five seconds for
icon to expire from
LCD screen. To use Turbo Mode, with engine running and key in the run
position, apply hand brake and remove key from snowmobile. Engine will
shut off when selected time expires. Option 1 = 30 seconds, 2 = 1 minute,
and 3 = 3 minutes,
see chart on page 17
.
Note: RPM cutoff is active during Turbo Mode but brake cutoff is not.
For Valet Mode, insert the key back into the ignition before the timer ex-
pires and turn to run position. (Do not turn to start position as starter dam-
age could occur) Apply the hand brake - now Turbo Mode is deactivated
and snowmobile can be driven again.
Feature 4 - RPM Cutoff
This feature will adjust the RPM cutoff during remote start operation. This
feature should be left on the default setting. (Option #1 Very Low)
Options 2 through 5 can be used if you are running a fuel controller. If
your running a fuel controller and the RPM cutoff is too low or too high,
you can try options 2 through 5. Contact us at support@sledstart.com for
further assistance.
Feature 5 - Lights Flashing/Constant
This feature will adjust whether the lights will flash or remain constant dur-
ing remote start. This feature should be left on Option 1 as the headlight
is always on when the snowmobile is running, not allowing for flashing to
occur. When Option 1 is selected, the user can hear the click from the
