12
STEP 7
Find the best wire routing and use the supplied wire loom and cable ties.
If possible, just route the loom along with other wires and cable tie away
from any extreme heat. Be cautious of anywhere the wire or wire loom
can rub over time. Save the two large heavy duty cable ties for mounting
the module in Step 8.
STEP 8
Using the included 14" heavy duty cable ties, mount the SledStart mod-
ule to the snowmobile. It is always best to install the module in a dry lo-
cation where it can sense the under hood temperatures when the Tem-
perature Autostart feature is used. The module will then know when the
engine is at the user-selected temperature so it can perform a restart. For
more info on Temperature Autostart see page 16.
STEP 9
Mount the antenna by removing film off sticky pad on the antenna base
and stick to the highest possible location. For locations on different snow-
mobile models, see our website at
www.SledStart.com
STEP 10
Attach the red 12V lead from the SledStart module with the 30 amp fuse
removed to the battery positive pole along with the factory ring connec-
tor. Next install the Pink/white and Black wires from the SledStart module
to the battery's negative pole along with the factory ring connector.
After installation is complete and you have checked all the connections
and all wires are cleanly routed and inserted into the split loom, insert the
30-amp fuse in the red 12-volt wire going to the positive side of the bat-
tery.
STEP 11
Install the included AAA battery into the two-way LCD remote control trans-
mitter. A self-test of all icons will perform along with a single beep.
At this time, if you plan on using your one way remote as a backup, re-
move battery cover and insert the included coin battery. Note: the one
way remote will only operate the Manual Remote Start mode, the Timer
Start Mode and the Turbo Mode. No programming can be done with the
one way remote.
Refer to page 13
for more info on the one way remote.
