14
SSSSS
AFETY
AFETY
AFETY
AFETY
AFETY
T
T
T
T
T
ESTING
ESTING
ESTING
ESTING
ESTING
T
T
T
T
T
HE
HE
HE
HE
HE
S
S
S
S
S
YSTEM
YSTEM
YSTEM
YSTEM
YSTEM
After steps 1 thru10 in the installation section are completed and you have
confirmed the LCD remote is code matched to the SledStart module the
system can be tested.
Start by making sure the parking brake on the snowmobile is set and the
clutch guards and covers are in place. Be sure the bypass toggle switch
is set to ON and the snowmobile kill switch is not on. Press the "S" but-
ton on the LCD remote. A flash from the headlight should follow confirm-
ing the command. You will hear the ignition and fuel pump kick in followed
by the starter cranking and starting the engine. The LCD remote will con-
firm a successful start by a three-note music tone and the exhaust cloud
will appear. Press "S" again to shut the engine off. Next the ignition and
the SledStart module will shut down along with three shut down tones from
the LCD transmitter.
Once the engine is off turn the bypass toggle switch to the OFF position.
Press the "S" button on the LCD remote. The snowmobile should NOT
start. Next remove the clutch cover that operates the pin switch. DO NOT
REMOVE TOP CLUTCH GUARD! Turn the toggle switch back to the ON
position. Be sure all body parts are clear of the clutch area. Stand away
from the clutch area and press the "S" button on the LCD remote. The
snowmobile should NOT start.
If the snowmobile starts in either the toggle or pin switch test CEASE USE
IMMEADETALY and review the installation pages. Be sure these two
switches function properly.
