8
IIIII
NSTALLATION
NSTALLATION
NSTALLATION
NSTALLATION
NSTALLATION
CAUTION:
Prior to installation, please be certain that the 30-amp fuse in the
red 12-volt wire from the SledStart module is removed and the
snowmobile battery is disconnected!!!!!
The SledStart Remote Starter System was designed to be a true plug-
and-play system, making it easy for the user to install. Installation will con-
sist of plugging the pre-wired piggybacked connectors from the SledStart
module into the snowmobile's ignition switch connector, brake switch con-
nector, and one of the fuel injectors. There is also a positive and nega-
tive battery hookup along with mounting a pin switch for the clutch side
body panel and a bypass toggle switch. The mounting of the SledStart
module itself will vary model to model. The best location for the Apex is
inside the steering gate on the clutch side of the snowmobile. Please visit
our website
www.sledstart.com
for detailed pictures of this location. It is
important to note the direction the module will face to avoid damage to
the antenna wire. At the time this manual went to print, not all mount lo-
cations for all models have been tested. Please see our website as we
will have updates on there as they become available. Any location that
will not see excessive amounts of heat, snow pack or water is suitable.
Be careful of mounting module near any steering components as these
parts need to move free and clear of any obstacle. It is suggested that
you inspect the module after your first ride especially for deep powder
riding. The SledStart module is specially coated internally to prevent dam-
age from moisture, but excessive snow pack can cause moisture issues.
Snow pack could also cause overheating of the internal relays if the mod-
ule does not have ample ventilation. If you ride EXTREMELY hard it may
be a good idea to insert a piece of foam between the module and the
mounting surface to help reduce shock. We saw no failure due to this in
testing, but it may not be a bad idea.
NOTE 1:
You will notice the gray/black wire with the bypass toggle switch
bundled together after removing from the package. Leave this bundled
until step 5 as it will make installation easier and reduce risk of breaking
the wires from the toggle switch.
NOTE 2:
The violet wire from the SledStart module is only used if you
are running Rock's Warm Hands Controller or "YamaHeater". If you plug
the Violet wire with the male spade connector from the Sledstart Module
to the Violet wire with the female spade connector from the Yamaheater,
your Yamaheater will now turn on when you remote start your snowmo-
bile. This will provide nice toasty hand grips before you go riding!
