The MOJO
™
Full Face Mask
Trouble Shooting
If the tensioning wheel has unscrewed from its post, it can be re-
screwed into place. Hold the mask shell with your thumb inside the
shell, pressed against the base of the post; wrap your fingers around
the dual beam element, as illustrated, and replace the tensioning
screw inside its slot, perpendicular to the post. Turn the screw
clockwise until it threads on the post.
General Information
• Sizes Small, Medium, Large
• 90 day warranty against manufacturer’s defects
• Wash mask on a daily basis with mild soap and water
• CE Mark 0123; latex free, hypoallergenic
• Negligible pressure drop throughout mask system
• Compatible with all positive airway pressure devices
Mask Care
Clean mask daily with mild soap and water; allow to air dry. Store in a cool, dry place away from
excessive heat and excessive cold.
DO NOT use excessive and repeated force to bend the pliable ring or nose clip. The wire may lose
flexibility and prevent the mask from forming a seal.
DO NOT
clean the mask in a washing machine or dish washer.
DO NOT
puncture or tear the gel cushion. The gel is non-toxic, but can leak out. Damage to the gel
cushion will prevent the mask from forming a seal and will create air leak; if the gel cushion
is damaged, the mask must be replaced. This type of damage is not covered by our warranty.
DO NOT try to repair gel cushion with tape or adhesive.
DO NOT block swivel vent holes; this will cause patient to re-breathe exhaled air.
• Breath-O-Prene
®
SILVERtec
™
fabric
- Antimicrobial
- Maximizes breathability
- Latex free and adhesive free
• One size, comfortable and secure
Mojo Headgear
#55045
Mojo Mask, Large, with Mojo Headgear
#50837
Mojo Mask, Medium, with Mojo Headgear
#50836
Mojo Mask, Small, with Mojo Headgear
#50835
