www.SleepPhones.com
OPERATING INSTRUCTIONS
VOLUME:
Click the “up” arrow button to increase the volume. Holding the
“up” arrow button will also increase the volume at a faster pace. Click the
“down” arrow button to decrease the volume. Holding the “down” arrow
button will also decrease the volume at a faster pace.
SKIP TRACK(S):
Double click the “up” arrow button to advance to the next
track. Double click the “down” arrow button to go to the previous track.
PAUSE:
Click the middle square button once to pause the music. Click once
again to resume playing music.
POWER OFF:
To turn the device off, press and hold the middle square button
for 3 seconds. You will hear a descending 3 ring tone.
While charging, if the red light is on, the module is not fully charged.
If there is
NO
light on at all while charging, the Bluetooth
®
module is
fully charged.
NOT SURE IF FULLY
CHARGED
UNABLE TO PAIR
FOR THE FIRST TIME
When you turn on the device, make sure to continue holding down the
button for a full 5 seconds until you hear an ascending 3 ring tone followed
by a series of beeps. The beeps indicate that the module is in pairing mode.
UNABLE TO PAIR
If your Bluetooth
®
enabled device is unable to pair with the AcousticSheep
®
module, you may need to reset the Bluetooth
®
module. To reset the
Bluetooth
®
module, turn it on. Hold both the “up” and “down” arrow
buttons down for 7 seconds. Once the reset function is complete there
will be two long tones. The Bluetooth
®
module must be turned off and
then turned back on for it to enter into pairing mode.
UNABLE TO FIND
THE DEVICE
If your AcousticSheep
®
module was previously paired with another device,
it will automatically pair with that device if the device is within range.
Make sure that the Bluetooth
®
on all other previously paired devices is
turned off or out of range when you are pairing with a new device.
Slide the speakers inside the headband to position them over your ears.
Check the volume on your Bluetooth
®
audio player.
Check the volume on the wireless Bluetooth
®
module located inside
the headband.
Make sure that the wireless Bluetooth
®
module is charged.
If your Bluetooth
®
device is separated from your SleepPhones
®
Wireless
headphones for more than 5 minutes, the headphones will automatically
power off. Not all applications or software support Bluetooth
®
.
1
2
3
4
THERE IS NO SOUND
WHEN PAIRED
TROUBLESHOOTING
Quick Start Guide
5
