3629 Reed Creek Dr. / Bassett, VA 24055
Toll Free: 866.852.2337
SleepSafeBed.com
sleepsafebed@sleepsafebed.com
RETROFIT KIT
LOWER SAFETY RAILS.
REMOVE MATTRESS.
LOOSEN 3 SCREWS, REMOVE 1
IN THE 2ND BED DECK PANEL.
With 4mm Allen Wrench (or drill with bit),
loosen 3 screws and remove 1 in the deck
panel as shown. The purpose is to allow
room to feed the strap beneath the deck.
How to install a Dreama
TM
System into a SleepSafe® Bed
Includes:
Dreama
TM
24hr Positioning System; Deck Pad; Deck Strap; Deck Screws
Tools Needed:
4mm Allen Wrench (Included) or Drill with 4mm Allen Bit
FEED THE STRAP BENEATH
BOTH SIDES OF THE DECK PANEL.
Feed the strap beneath the deck. The buckle
should line up with the loosened screw.
Once buckle in place, replace removed screw,
and then tighten all the screws.
BUCKLE
POSITION ON DECK
PLACE PAD
ON TO THE DECK.
BUCK LE
POSITION ON
PAD
PLACE PAD
ON TOP OF
THE DECK.
HEADBOARD
Loosen
Screw
LOOSENED
SCREW
Remove Screw
Loosen Screw
STRAP IS FED BENEATH THIS DECK PANEL
EXCESS STRAP
USED TO SECURE
DREAMA TO BED
PLACE PAD ON TOP OF DECK
INSIDE THE SLEEPSAFE BED.
EXCESS STRAP
Note the position
of the strap
buckle once the
pad is placed on
top of the deck.
Loosen
Screw
