19
7240
6
2022
-
E300
MG_0524
Wiring Diagram 48V Thruster
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
Fuse 5A
The Top wiring setup is for a single
bow or stern thruster system
Automatic Main Switch *
ANL Fuse
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
++
12V
THRUSTER
BATTERY
Fuse 5A
Automatic Main Switch *
ANL Fuse
The below represents the wiring
setup using a dual thruster system
with a bow and stern thruster.
WARNING
Battery terminal polarity must be
observed and connected correctly
IMPORTANT
AMS must be supplied with 24V only
(Use AMS serial #0 017664 or higher)
S-Link Spur cable
S-Link Spur cable
S-Link Backbone cable
S-Link Backbone cable
Refer to the User and Installation Manual of the
control panel to be installed for detailed installation
instructions.
See S-Link System Description chapter for detailed
information on installation of S-Link Power cable
and additional S-Link components.
Selection of battery, fuse, main switch and cable cross section is described in
Electrical
Installation
chapter.
S-Link Spur cable
Control
panel
*Automatic Main Switch can be replaced by a fuse holder and manual main switch.