7
2917
14
2020
-
PJC 211 & 212
Press the button below
to return to the previous menu.
Press the button below
to edit the selected parameter.
Parameter value will start to blink, use joystick to alter value.
Press the button below
to save edited parameter to device
Press the button below
to cancel editing without saving.
Control Panel Setup Buttons
MC_0115
Setup
Default in systems
without stabilizers
Combining Stabilizer with AC & DC Thrusters
MC_0115
Setup
SETUP
NOTICE regarding following Location modes: If the boat has Sleipner stabilizer and AC or DC thrusters the thruster
location should be set as BOW-STB or STERN-STB. This so the hydraulic controller are shown at the left side in display
and thruster(s) at the right side of the display.
Default in systems
without stabilizers
HYD-DC
HYD-AC
HYD-AC-DC
PDC 101
(SAC Controller) (This device is not able to edit. Pre-setup from factory.)
PDC101 must be setup by authorized personnel.
Firmware version and serial number is Not Available (NA).
Location
Values: BOW/STERN/BOW-STB/STERN-STB
BOW or STERN in a conventional thruster system.
In a system with two bow or stern thrusters (i.e a catamaran),
BOW and STERN is port thruster, BOW-STB and STERN-STB
is starboard thruster.
(NB: If the boat has Sleipner stabilizer and AC or DC thrusters the thruster location should be set as BOW-STB
or STERN-STB. This so the hydraulic controller are shown at the left side in display and thruster(s) at the right
side of the display.)
Direction
Values: NA (Not Available)
AC System - PDC 101 Setup
AC System - PDC 201 Setup
MC_0096
MC_0096
PDC 201
Location
Values: BOW/STERN/BOW-STB/STERN-STB
Set the location for selected device. Use BOW or STERN in a conven tional thruster system. In a system
with two bow or stern thrusters (i.e a catamaran), use BOW or STERN for port thruster, BOW-STB or
STERN-STB for starboard thruster.
(NB: If the boat has Sleipner stabilizer and AC or DC thrusters the thruster location should be set as
BOW-STB or STERN-STB. This so the hydraulic controller are shown at the left side in display and
thruster(s) at the right side of the display.)
Direction
Values: Normal (default)/Inverted
Switches between Normal and Inverted
running direction for the thruster.
3.0
3.1
3.2
4.0
4.1
4.2
