CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON A
HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in
“accessory” or “on” position. Please make sure emergency brake is set and car is
in park.
2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
3. ALWAYS use a pressure gauge to check actual tire pressure.
DO NOT OVERINFLATE!
4. Read all instructions thoroughly before use. Failure to follow warning instructions
can result in fire, injury to persons or property damage.
5. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
6. Keep inflator out of reach of children.
1
2
3
1. Screw air hose connector onto tire's valve stem.
2. Plug power cord into 12 volt accessory power outlet.
3. Press on switch to turn on inflator. Inflate tire to manufacturer's recommended air
pressure.* When proper pressure is reached, press off switch to turn off inflator. Unplug
power cord and remove air hose connector.
*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's side
door jamb.
INFLATE TIRES
INFLATE RIGHT™ TECHNOLOGY INSTRUCTIONS:
1. Hold the + or – button for approximately 5 seconds until the display flashes.
Set the required pressure using the + or – buttons, then wait 2-3 seconds.
The display will show the pressure value to which the tire will be inflated.
2. Push the ON/OFF button for the inflator to start. When the pressure gauge reaches the
pre-set value, the inflator will automatically switch off.
3. The ON/OFF button can be used to override the pre-set pressure value if required.
