11
The “second” value flashes. Press the MODE button (+) or RESET button (
-
) to correct the value to
“00” (sec.).
Press the button according to the time signal.
After confirming the value, press the DATA button.
The “minute” value flashes. Press the MODE button (+) or RESET button (
-
) to correct the value.
You can quickly increase or decrease the value by long pressing the button.
After confirming the value, press the DATA button.
The “hour” value flashes. Correct the value in the same way as you do for the “minute” value.
After confirming the value, press the DATA button.
The display changes to the calendar correction display.
p.22
ղ
Calendar correction
The “day” value flashes. Press the MODE button (+) or RESET button (
-
) to correct the value.
You can quickly increase or decrease the value by long pressing the button.
After confirming the value, press the DATA button.
The “month” value flashes. Correct the “month” and “year” values in the same way as you do for the
“day” value.
After confirming each value, press the DATA button.
The display changes to the birthday setting display.
ճ
Birthday setting
The “day” value of the birthday flashes. Press the MODE button (+) or RESET button (
-
) to set a
value.
You can quickly increase or decrease the value by long pressing the button.
After confirming the value, press the DATA button.
The “month” value of the birthday flashes. Set a value in the same way as you do for the “day”
value.
After confirming the value, press the DATA button.
The display changes to the contrast setting display.
p.23
մ
Contrast setting (setting range: -3 to +3)
The contrast value flashes. Press the MODE button (+) or RESET button (
-
) to set a value.
After confirming the value, press the DATA button.
•
If the pedometer is not operated for a few minutes during data setting, the display will change to
the “watch” or “calendar” display.
Birthday message
By setting your birthday, the birthday message is displayed by scrolling for 10 minutes from every
hour.
Pressing any button returns to the previous display.
•
If this setting is left at the factory default setting, the birthday message will be displayed on
January 1.
12
p.24 HOW TO CHANGE BATTERY
TOROUBLE SHOOTING
When the mark is displayed on the display, the battery has run down. Replace the battery
according to the following procedures.
If you press any button when the mark is displayed, the mark will disappear and the display
will return to the previous one. However, the mark will be displayed again at midnight the next
day.
•
Please note that all data will be deleted after the replacement of the battery.
Screw on the battery cover
SYSTEM RESET switch
ձ
Remove the screw on the battery cover with a commercially available small Phillips screwdriver.
Be careful not to lose the screw.
ղ
Open the battery cover and remove the worn battery. Insert a new battery (lithium battery
CR1620) with the positive (+) side upward.
ճ
Reinstall the battery cover and fix it with the screw.
մ
Press the SYSTEM RESET switch with a pen tip or the like.
p.25 Battery Life
The battery life is approximately 8 months when the pedometer is used for 8 hours a day. However,
the battery may run down earlier than the specified life since a monitor battery is inserted at the
time of purchase.
Resetting
By pressing the SYSTEM RESET switch after changing the battery, all data is deleted and the
screen changes to the stride length setting screen. Perform resetting.
Personal data setting
Ѝ
Page 4
Setting of the watch, calendar, birthday and contrast
Ѝ
Page 21
•
If the pedometer is not operated for a few minutes during data setting, the screen changes to the
“number of steps” display.
p.26
When trouble occurs during use, check the following first.
If the trouble is not resolved even after checking, contact the retailer from whom the pedometer was
purchased or the nearest SEIKO SPORTS LIFE office.
g
n
i
w
o
l
l
o
f
e
h
t
k
c
e
h
C
m
e
l
b
o
r
P
Nothing is displayed on the
display screen.
- The battery may run down. Replace the battery with a new one.
Ѝ
Page 24
- The polarities of the battery may not be correct. Insert the battery
with the correct polarities.
Ѝ
Page 24
The displayed value is
different from the actual
Check the wearing method and walking condition.
Ѝ
Pages 6
and 14
ձ
Watch correction
