Sling Media SlingCatcher, User Manual

7

STEP 6:

 TURN ON YOUR TV

Wait approximately one minute for SlingCatcher and your TV to warm up. 
If necessary, change your TV video input source setting to match the input 
that you’ve connected SlingCatcher to.  For example, if your SlingCatcher is 
connected to A/V Device 1 on your TV, set your TV to display A/V Device 1.

It may not be obvious how to change the input source setting on your TV. Again, 
you may need to refer to the manual for your TV for information. If you don’t have 
the manual, many manufacturers also have these manuals on their website.
 
After you choose the correct input source setting, a Welcome screen appears. 
On-screen instructions will lead you through the step-by-step process for 
configuring your SlingCatcher.

IF YOU DO NOT SEE THE WELCOME SCREEN AT THIS POINT:

First, wait at least an additional 30 seconds to make sure that both SlingCatcher 
and your TV are warmed up. Double-check the TV input source setting. If your 
TV and SlingCatcher are warmed up and you’ve selected the correct Input 
source setting, it’s possible that your TV is not set to accept the video format 
being output by SlingCatcher. Press the ENTER (      ) button on the SlingCatcher 
remote control every 5 seconds to change the video format being output by 
SlingCatcher until you see the SlingCatcher Welcome screen clearly on your TV.

If this does not work, see page 10 of this manual for more troubleshooting tips.

ENTER button