Page
15
of
21
15.
If the Inside Tube gets hung-up on the Lower Bushing in the Outside Tube and will not pass through it
then while holding both upward with the Lower Bushing down at the bottom, reach a finger into the
Outside Tube and push the leading edge of the Inside Tube inward and free of that bushing, that will
allow it to pass through.
16.
Next you will reattach the Foot. Align the holes at the top of the Foot with the bottom holes in the Inside
Tube. Slide a Foot Bolt through the Foot from the side with the round holes (the other side has the hex
shaped holes to accept the Foot Nut), push it through one of the Nylon Foot Washers, then through the
Inside Tube, through another Nylon Foot Washer, then through the other side of the Foot. Next use one
hand to push a Foot Nut into the Foot from the hex shaped side hole so that it is fully recessed in the
Foot and hold it in there with some light pressure from your finger, then use your other hand to tighten
that Foot Bolt into the Foot Nut using the
5/32” Allen key. Tighten the bolt down until it is snug but do
not overtighten as it will warp the Foot posts inward. Then repeat this process for the other Foot Bolt.
