007 TURBO INSTRUCTION MANUAL
007 TURBO INSTRUCTION MANUAL
LAUNChING & LANdING
Just before launching your kite, have a friend hold your kite in the launch position at
the side of the wind window and do a visual check to make sure you have no tangles
in your lines or bridle and they are attached correctly to your kite.
STEP 1
Find an open area with unobstructed
steady wind. Make sure there aren’t
any rocks, trees, fences, cars, power
lines or people downwind of you or in
your wind window.
STEP 2
Have your launching partner walk your
kite to the edge of the wind window
and have them turn the kite on its
side and hold the leading edge facing
towards the wind.
STEP 3
Make sure your Active Stopper Ball is
pushed out for maximum de-power.
STEP 4 + 5
Signal to your launching partner that
you’re ready to launch, and as they let
go of your kite, pull the top half of your
bar towards you to slowly raise your kite
into the sky to the neutral position.
STEP 6
Get in the water quickly and enjoy
your session!
NOTE
- If there is any
sand or grit on your bar or chicken loop
line. Submerge the bar in the water
to cleanse the product for a properly
working system. This will increase the
overall life of your bar, chicken loop rope
and cleat.
Summary of Contents for TURBO 2
Page 1: ...2007TURBO2 INSTRUCTION MANUAL...
Page 33: ...33...