007 TURBO INSTRUCTION MANUAL
007 TURBO INSTRUCTION MANUAL
STEP 1
To perform a controlled relaunch, push
the Active Stopper Ball way from you
until it meets the yellow stopper ball and
determine in which direction you want
your kite to launch.
STEP 2
If you want the kite to launch to your
left, pull in the right side of the bar and
grab the right trailing edge leader line
and pull toward you. You may have to
pull the entire leader line to make the
kite roll up on its wing tip. If you decide
to launch the kite to the right, perform
the procedure on the left side of the bar.
STEP 3
As the kite rolls over onto its wingtip
expect to let a little bit of leader line out
to keep the kite balanced on its wingtip.
Continue to hold the leader line and
move the kite to the edge of the win-
dow. As you work the kite to the edge,
sheet out for a controlled relaunch.
STEP 4
When the kite is ready to launch, slowly
release the outside leader line and
place both hands back on the bar.
Once
airborne, steer the kite to the neutral
overhead position and prepare to ride.
RELAUNCH TIP:
If the kite lands
leading edge toward you, pull as much
outside line as you can on one side until
the kite starts to turn around. Once the
kite starts to rotate, start pulling on the
opposite outside line to complete the
rotation. This is a bit tricky and will take
some practice to accomplish. Don’t be
afraid to be fairly aggressive with your
leader lines. When the kite is directly
downwind and on its leading edge,
follow the standard water relaunch
sequence.
Note:
When handling flying
lines, make sure not to tangle the line
around any body parts or equipment.
RELAUNChING ON WATER
1
2
3
4
LAUNChING & LANdING
Summary of Contents for TURBO 2
Page 1: ...2007TURBO2 INSTRUCTION MANUAL...
Page 33: ...33...